Skip to main content

FlashScan V2 Flash & License a Controller - Knowledgebase / FlashScan V2 / FlashScan V2 Vehicle Communications - EFILive Service Desk

FlashScan V2 Flash & License a Controller

Authors list
  1. Configure FlashScan V2 for BBX features if not already setup.
  2. Copy selected tune file(s) from your PC to FlashScan V2 if not already copied via Quick Setup in step 1.
  3. Connect your FlashScan V2 device to your vehicle.
  4. Turn the vehicle ignition to the On position (not the Accessory position.  Vehicle must not be cranked/running when flashing).
  5. Navigate to the F2 Tune Tool -> F1 Tuning and select either F2 Program Cal or F3 Program Full menu option.
  6. Using the arrow keys, navigate to the correct tune file and select OK.
  7. If the controller has not been licensed by this FlashScan V2 previously, you will be presented with the License this controller now? message.  Select Yes to license the controller or No to exit without licensing the controller..
  8. Select Yes to confirm licensing the controller and commence the flash, or No to exit without licensing the controller.

  9. When the flash process is complete the Reset Controller notification will be shown.   When prompted perform the following actions:
    1. Turn the vehicle ignition Off.
    2. Click on the Start button to begin the countdown timer.
    3. DO NOT turn the vehicle ignition on until the countdown timer expires.  This time is critical to allow the ECM to perform internal functions after a read operation.

Helpful Unhelpful

6 of 12 people found this page helpful

Add a comment

Please log in or register to submit a comment.

Need a password reminder?