Skip to main content

AutoCal V2 Data Logging - Knowledgebase / AutoCal V2 / AutoCal V2 Vehicle Communications - EFILive Service Desk

AutoCal V2 Data Logging

Authors list

Simple Menu:

Follow these steps to log the selected controller.

  1. Install AutoCal BBX configuration and tune files provided by your Tuner if not already setup.
  2. Connect your AutoCal device to your vehicle.
  3. Turn the vehicle ignition On.
  4. Navigate to the Select PIDs menu option and select OK.
  5. Select the correct controller type from BBX configured controllers and make a selection using the OK button.  Where only one controller is in the BBX, executing the Select PIDs option will make that selection and return to the menu.
  6. Navigate to the Record Data option and select OK to commence the logging session.  AutoCal will display the following to commence the logging session;
    1. Creating Log File.
    2. Starting Scanner.
  7. The Time indicator will increment to indicate recording has commenced.
  8. Start the vehicle and drive to record actual performance.
  9. Stop the vehicle and turn the ignition off prior to saving the log on AutoCal.
  10. A range of options are available while the log is recording:
    1. Select OK to pause/resume the log.
    2. Select Next to display the frames recorded.
    3. Select Prev, the OK to exit and save the log.

Advanced Menu:

  1. Install AutoCal BBX configuration and tune files provided by your Tuner if not already setup.
  2. Connect your AutoCal device to your vehicle.
  3. Turn the vehicle ignition On.
  4. Navigate to the Scan Tool menu and select OK.
  5. Navigate to the Select PIDs menu option and select OK.
  6. Select the correct controller type from BBX configured controllers and make a selection using the OK button.  Where only one controller is in the BBX, executing the Select PIDs option will make that selection and return to the menu.
  7. Navigate to the Record Data option and select OK to commence the logging session.  AutoCal will display the following to commence the logging session;
    1. Creating Log File.
    2. Starting Scanner.
  8. The Time indicator will increment to indicate recording has commenced.
  9. Start the vehicle and drive to record actual performance.
  10. Stop the vehicle and turn the ignition off prior to saving the log on AutoCal.
  11. A range of options are available while the log is recording:
    1. Select OK to pause/resume the log.
    2. Select Next to display the frames recorded.
    3. Select Prev, the OK to exit and save the log.
Helpful Unhelpful

2 of 3 people found this page helpful

Add a comment

Please log in or register to submit a comment.

Need a password reminder?