Follow these steps to find and/or update FlashScan V2 Firmware using the EFILive V8 Scan and Tune software.
- Ensure you have downloaded and installed the latest version of EFILive V8 Scan and Tune software, available here.
- Connect your FlashScan V2 device to your PC.
- Start the EFILive V8 Scan and Tune application.
- Click the [Check Firmware] button at the top of the window.
- Boot Block and Firmware versions, along with Configuration files are displayed.
- If a boot block update is available then the [Update Boot Block] button will be visible. You should click that button to update the firmware in the connected device.
- If a firmware update is available then an [Update Firmware] button will be visible. You should click that button to update the firmware in the connected device.
Note: If both the [Update Boot Block] and [Update Firmware] buttons are visible, then click the [Update Boot Block] button first unless advised otherwise by EFILive Support. - If updated configuration files are available then an [Update Files] button will be visible. You should click that button to update the configuration files in the connected device.
- If the information displayed in the window appears incomplete or if you have connected the device (or connected a different device) after opening the "Update Firmware and Configuration Files" window, then click the [Refresh] button to reload the information from the connected device.
- Click the [OK] button to close the Check Firmware window.
FlashScan V2 Device
Follow these steps to obtain the FlashScan V2 Boot Block and Firmware versions using the FlashScan V2 device keypad.
NOTE: Firmware and Boot Block can only be updated using EFILive V8 Scan and Tune software.
- Connect your FlashScan V2 device to your PC or vehicle (as a power source).
- Press the [F4 Options] key on the keypad.
- Press the [F3 About...] key on the keypad.
- Press the [F1 Firmware Details] key on the keypad.
- Scroll down the display using the Down Arrow key on the keypad until you get to the FIRMWARE section.
- The firmware version is shown in the Ver: field.
- Continue to scroll down the display using the Down Arrow key on the keypad until you get to the BOOT BLOCK section.
- The Boot Block version is shown in the Ver: field.
Add a comment
Please log in or register to submit a comment.